PHEW!!! I finaly found a set of seats that'll fit in my rail that'll allow me to put them between my frame wells (15 inches) and still sit low nough to give me some head room, without going UNDER the frame, so I won't have to build up under the frame. I DO need to run three pieces of flat rod though. Whats the "standard thickness" for seat mount flat stock?
Thanks all that have helped me with this seat ordeal. With 98days (but who counting) until my first trip and my first rail completly just rolling stock, I'm STARTING to get a bit stressed. I got the rail last season with the idea I'll make the needed "adjustments" over the Summer. Well the Summer is going by QUICK as far as getting the rail ready. I REALLY apreceate your help on this site.
Seat mount thicknes?
Moderator: Sitewide Forum Moderators
-
Sloppyduner
- CA Event Committee Chair
- Posts: 4012
- Joined: Tue Mar 18, 2003 11:17 pm
- Please enter the middle number: 5
- Location: continually being flung around the Sun
Seat mount thicknes?
....and at the end of that light there is another tunnel
-
Sand Commander
- 6th Gear "Wide Open" Member
- Posts: 1566
- Joined: Mon Jan 08, 2001 1:45 pm
- Please enter the middle number: 5
- Location: Huntington Beach, CA
I would say 1/8" thick if you are running three pieces and 1/4" if there are two runners.
Bill Jones
Apathy is the greatest danger to our freedom.
If you give in to fear and pain, there are thrills you will never know- North Dallas Forty
Government by the people has now been replaced by Government verses the people
The best argument against democracy is a five minute conversation with the average voter- Winston Churchill
Apathy is the greatest danger to our freedom.
If you give in to fear and pain, there are thrills you will never know- North Dallas Forty
Government by the people has now been replaced by Government verses the people
The best argument against democracy is a five minute conversation with the average voter- Winston Churchill
-
r erfert
- 5th Gear "Pinned" Member
- Posts: 685
- Joined: Wed Oct 15, 2003 11:25 pm
- Please enter the middle number: 5
- Location: Yuma, AZ
Re: Seat mount thicknes?
I usually use 2 flat steel pieces of 3/16" X 3" X length? for flat bottom seats.Sloppyduner wrote:With 98days (but who counting) until my first trip and my first rail completly just rolling stock, I'm STARTING to get a bit stressed. I got the rail last season with the idea I'll make the needed "adjustments" over the Summer. Well the Summer is going by QUICK as far as getting the rail ready. I REALLY apreceate your help on this site.
I totally understand the need to finish it up...In my case I need to get it done
get it sold and get some parking back 
