It only took 3 seasons...

SANDUNERS · Post by **SANDUNERS** » Wed Aug 17, 2005 12:26 pm

To finally get some paint on the frame...

Now to get it all back together...

Post by **jhitesma** » Wed Aug 17, 2005 12:45 pm

Looking good Jim! And you're still ahead of me. I've had the paint for two years but it's still not any closer to actually going on my frame

Crowdog · Post by **Crowdog** » Wed Aug 17, 2005 7:09 pm

Nice Bush/Cheney yard sign.

Frame looks good Jim.

OBSESSED · Post by **OBSESSED** » Wed Aug 17, 2005 8:44 pm

I don't get it...

The last color it was wasn't good enough?

You changed your mind from brown to yellow?

Your brown looked good, but this yellow does look nice...

S

Post by **BHenry** » Thu Aug 18, 2005 6:59 am

Looking good, Fearless Leader. You don't have that much time before the first trip

ddjthomas · Post by **ddjthomas** » Thu Aug 18, 2005 7:24 am

I like the skateboard for a dolly!!

Color looks good, who's frame is that?

SANDUNERS · Post by **SANDUNERS** » Thu Aug 18, 2005 11:49 am

Yes, I keep my old yard signs...

Brown, is that a color??? It wasn't brown, it was RUST on chromoly tubes...

If you go to Pismo or Oregon to ride expect to get some RUST...

Nothing like my old Hobie skateboard for a dolly, it came out of the trailer with it...

The frame is my 2001 built Extreme Performance. The day I picked it up the first and "new" double throwdown frame came back from powdercoating (green) and was displayed at the SSSS that year.

Time is running out for sure, I have just started to run my wires in the frame. I get the trans back next week and should have everything I need to bolt it back together again...

Picture this YELLOW...

Post by **BHenry** » Fri Aug 19, 2005 7:00 am

Well, if you don't get it back together in time, you can always borrow mine. Its all back together, turns out I had spun the right rear hub. The splines fell out when I pulled it off

Sand Commander · Post by **Sand Commander** » Fri Aug 19, 2005 9:25 am

Jim, Are you going to paint the side panels?

SANDUNERS · Post by **SANDUNERS** » Fri Aug 19, 2005 12:30 pm

Bryan, didn't I tell you that was it...

I learned the hard way, remove everything else then the hub...

Bill, the side panels ARE painted. They are Silver powdercoated and I did that and all the alum. work the first year. If your talking about getting new graphics (those are diecuts) not this year!!! (or next)

Post by **BHenry** » Fri Aug 19, 2005 3:35 pm

SANDUNERS wrote:Bryan, didn't I tell you that was it... I learned the hard way, remove everything else then the hub...

Fortunately, I didn't pull EVERYTHING, but I did dig deeper into the left side, thinking that was it, when it was actually the right hub. Cost me about $60 altogether

Sloppyduner · Post by **Sloppyduner** » Sat Sep 10, 2005 1:43 am

I like it. I hope this quick color does it justice.

I must of played with 20 different colors before I decided to keep mine the same color.